Filter
Top Products
Black plate (286,1)
3. “ENTER PIN” appears for 2 seconds
which indicates that it is in code input
mode.
4. “SR1 - - - -” appears which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example: If
the registered ID code is “ 2323”, input
“2323”. At this time “SR1 2323” is
displayed. Press the scan button after
the code is input.
(Registered ID code input
determination)
6. Determine the code which has bee n
input by pressing the scan butt on.
7. If it does not match the registered code,
“SR1 Err” is displayed and then it
returns to “SR1 - - - -”.
8. If it matches the registered code,
“SR1 LOCK” appears for 3 seconds
which indicates that the code input has
been completed.
9. “SR1 LOCK 100” appears which
indicates that the parental lock is
activated. At this time, mute is on and
no sound is heard.
(How to clear the message)
l
Press any of the following FM/AM,
SAT, CD, AUX, CAT, ESN/DISP,
Instant replay, POWER buttons.
l
Turn the ACC off or insert a CD.
NOTE
l
If an ID code is not input for 10 seconds,
“Err” is displayed and it returns to the
former display.
l
Channel preset buttons 1, 2, 3, 4 and the
scan button are used for input of the ID
code. Buttons 5 and 6 cannot be used.
Lock cancellation
Setting condition: SAT mode
(Releasing a locked channel)
1. Select a channel to be released by
turning the manual tuning dial.
Example: Select the locked channel
(i.e. 100). At this time,
“SR1 LOCK 100” is displayed.
(Registered ID code input preparation)
2. Hold the scan button, then press
channel preset button 6, hold both
buttons together for 1.5 seconds.
3. “ENTER PIN” appears for 2 seconds
which indicates that it is in code input
mode.
4. “SR1 - - - -” appears, which indicates
that it is ready for code input.
(Registered ID code input)
5. Input the registered ID code using
channel preset buttons 1-4. Example:
When the registered ID code is “2323”,
input “2323”. At this time “SR1 2323”
is displayed. Press the scan button after
the code is input.
NOTE
If “Err” is displayed, go to the
“INITIALIZATION OF ID CODE” section to
reset the ID code to [0000].
(Registered ID code input
determination)
6. Determine the input code by pressing
the scan button.
7. If it does not match the registered code,
“SR1 Err” is displayed and then it
returns to “SR1 - - - -”.
6-46
Interior Comfort
Audio System
CX-9_8Z66-EA-08F_Edition1 Page286
Thursday, May 29 2008 10:8 AM
Form No.8Z66-EA-08F