Filter
Top Products
Black plate (94,1)
2. Remove the retainer bar from the rear
seatback position.
3. Insert the retainer bar anchors into the
left side of each rear seatback retainer
(back of the seatback).
Retainer bar
Rear seat
Retainer
4. Slide the retainer bar in the direction
indicated in the figure, and engage the
anchors into the seatback retainers.
Retainer bar
5. Slowly pull out the net in the upward
direction, insert the left and right net
anchors into the ceiling retainers, and
slide them to the position indicated in
the figure.
Net
anchor
Net
To remove the net:
1. Lift the net slightly and disengage the
net anchors from the ceiling retainers.
2. Slowly lower and support the net as it
rolls up into the retainer bar.
3. Remove the retainer bar in the reverse
order of installation.
CAUTION
When disengaging the net anchors,
hold the top of the net firmly in your
hand. If you lose control of the net, it
will automatically roll up in an
uncontrolled manner and could
cause injury.
3-18
Knowing YourMazda
Doors and Locks
Mazda6_8X47-EA-07G_Edition1 Page94
Tuesday, May 29 2007 3:43 PM
Form No.8X47-EA-07G