Filter
Top Products
®®
connected or disconnected. Please follow recommended practices for installing NMEA 2000
®
network products.
Figure 7 – NMEA 2000
®
Connector Face Views
3 Configuring the FFM100
The FFM100 has several configurable parameters, which are shown below including the
default values. If you are not using the default values, then you will need to refer to the
corresponding section for configuring the FFM100 appropriately.
1. Advanced Configuration (Section 3.1)
a. Device Instance
b. Channel-0 Installation
c. Channel-1 Installation
d. Channel-0 Allow negative flow
e. Channel-1 Allow negative flow
f. Differential Mode Allow negative flow
g. Installation Description
h. NMEA 2000 PGN Enable/Disable
i. Restore Factory Defaults
2. Device Label (Section 3.2)
3. Operating Mode (Section 3.3)
4. Channel #0 (Section 3.4)
a. Channel Enable/Disable (Section 3.4.1)
b. Engine Instance (Section 3.4.2)
c. Engine Label (Section 3.4.3)
d. K-Factor (Section 3.4.4)
e. Data Damping Period (Section 3.4.5)
f. Reset Total Volume Recorded (Section 3.4.6)
g. Temperature Instance (Section 3.4.7)
h. Temperature Source (Section 3.4.8)
i. Temperature Label (Section 3.4.9)
Revision 1.2 Page 11