Filter
Top Products
Points of Interest
32
Marking Your Position (Personalized)
Normally, marking your position is simply a two-button process: MARK and ENTER.
However, sometimes you will want to personalize the POI you are marking to make it
easier to identify later. You are able to change the icon, set the visibility, change the
name, and create a message. You are also able to change the location coordinates and
the elevation. This changes the position that is being saved and is discussed in a
following section.
1. Press
MARK.
2. Use the
Arrow joystick to highlight the field you want
to change.
3. Press ENTER.
4a. If the icon field was selected: Use the Arrow joystick
to select the icon desired and press
ENTER. To aid in
your selection, the type of icon selected is displayed in
the information block at the top of the keypad.
4b. If the Name field is selected: Use the
Arrow joystick
to select the character desired and press ENTER. If
you make a mistake, highlight
Back and press ENTER.
To access the lower-case characters, highlight Shift
and press ENTER. To clear everything and start over, highlight CLEAR and
press
ENTER. When you are satisfied with the name, highlight OK and press
ENTER.
Note: User-saved POI names can be up to 20 characters long (including
spaces).
4c. If the Message field is selected: Use the keypad displayed, just as was
described in 4b, to enter a message for this POI. Message fields can have
up to 45 characters, including spaces.
4d. If the V
is (Visibility) field is selected: Press
ENTER. Select On or Off and
Press
ENTER.
5. When the Icon, Visibility, Name, and Message fields are done, use the Arrow
joystick to highlight Save.
6. Press
ENTER.
7. Select the file to save the POI in and press
ENTER.
Mark Screen with Name
field highlighted