Filter
Top Products
10
Navigate a Back Trail
1. Press
MENU|↓ to NAVIGATE TRAIL|ENT.
2. Now, begin moving and follow your iFINDER's instructions.
On the map, your original trail is visible as a flashing solid line, along
with a roughly parallel dotted line indicating the back trail to follow.
The map contains a steer arrow in the lower right corner. This arrow
shows you where to steer to reach the next waypoint on your back trail.
When you Navigate a trail, the iFINDER gives navigation instructions on
both the Map and Navigation pages.
The Navigation Page will also show the trail line and a bearing arrow,
which points to the next waypoint on the trail.
As you travel, the arrival alarm will go off when you near a trail
waypoint, and the steer arrow (on the map) and bearing arrow (on the
compass rose) will swing around and point to the next trail waypoint.
Press
EXIT to clear the alarm.
To stop navigating along the trail, use the Cancel Navigation command.
Clearing or Erasing a Trail
You can erase the current trail and automatically begin recording a
new one by using the Clear Trail command.
1. Press
MENU|↓ to CLEAR TRAIL|ENT. iFINDER asks if you're sure; press
←
|ENT. 2. Return to the page by pressing EXIT.
Trail line
Trail
waypoint
symbol
Present
position
arrow
North
Bearing
arrow
Steer
arrow
Trail
waypoint
symbol