Filter
Top Products
130
5. To set the alarm percentage, press → to highlight
PERCENT and press
ENT.
6. Use ↑ ↓, ← → to input the desired percentage and press
ENT. Repeat
Steps 3-4 to set the other alarm.
7. Highlight
SET CONFIGURATION and press ENT to finalize alarm settings.
Press
EXIT repeatedly to get back to the main display.
NOTE:
To turn off (uncheck) an alarm, highlight its
ENABLED BOX and press
ENTER.
Waypoint Sharing
Waypoint Sharing allows you to share a waypoint from one display unit
with display units across the network.
To turn on/off Waypoint Sharing:
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
WAYPOINT SHARING and press ENT which will turn on/off way-
point sharing.
3. Press
EXIT repeatedly to get return to the main display.
Backlight Synchronization
The Backlight Synchronization command will keep all display unit
backlight levels consistent across the NMEA 2000 network. So, if you
set the backlight level to 75% on one display unit, all other units on the
network will automatically switch to the same setting.
To turn on/off Backlight Synchronization:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
BACKLIGHT SYNCHRONIZATION and press ENT, which will turn
on/off Backlight Synchronization.
3. Press
EXIT repeatedly to get back to the main display.
Configuring EP Sensors
All configurable devices are configured through their Device Configura-
tion menus, which may be accessed through the network devices list on
the Bus Configuration menu.
EP-35 Temperature Configuration
To input Device Name:
1. Press MENU|MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.