Filter
Top Products
147
If the amount of fuel you added to the tank and the fuel used figure are
off by more than 3 percent, we recommend the engine interface be cali-
brated.
NOTE:
You must use the gauge's Fill Tank command when filling your fuel
tank to keep the engine interface updated with correct information
on the amount of fuel in the tank.
To calibrate a Suzuki Engine Interface:
10. If calibration is necessary, press MENU|MENU, select NMEA 2000 and
press
ENT.
11. Highlight
FUEL MANAGEMENT and press ENT.
12. Select
TANK LOCATION and press ENT to choose the location of the tank
connected to the selected engine interface. Press
ENT.
13. Highlight
FILL TANK and press ENT. The following message will ap-
pear: Are you sure you wish to Fill Tank? Select
YES and press ENT.
14. The following message will appear: Do you wish to re-calibrate the
device? Select
YES and press ENT.
15. Repeat these steps for each engine interface you want to calibrate.
Engine Trim Calibration
Engine Trim is calibrated through the Suzuki Engine Interface Device
Configuration menu.
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Choose
BUS SETUP and press ENTER. Select the Suzuki Engine Inter-
face connected to the desired engine and press
ENT.
3. Highlight
CALIBRATE TRIM and press ENT. The Device Calibration win-
dow will appear with a list of Calibration Instructions.
4. Highlight
START CALIBRATION and press ENT. The following message
will appear: Please fully raise the Engine Trim.
5. After engine trim has been fully raised, press
ENT. The following
message will appear: Please fully lower the Engine trim.
6. After engine trim has been fully lowered, press
ENT. A Calibration
Completed message will appear. Press
ENT.
7. Repeat these instructions to adjust the engine trim for each engine
connected to a Suzuki Engine Interface. Press
EXIT repeatedly to return
to the main display.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de