Reference Station GPS1200+ 79
Configure a NET
port step-by-step
In order to use a NET port for the remote interface connection, the RJ45 connector
of the GRX1200+/GRX1200+ GNSS must be connected to a network hub or router.
If connecting directly to a PC, a crossed Ethernet cable is required. The following
step-by-step description shows how to configure a NET port and assign the remote
interface to it. Refer to the GPS1200+ Technical Reference Manual and to the
"GRX1200+ Series - Getting Started" for more information.
Step Description
1. Main Menu: Config...\Instrument Settings...\Set NET Parameters
2. CONFIGURE Set NET Parameters
Enter the Internet Protocol address, the network mask and the gateway.
3. CONT (F1) returns to GPS1200+ Main Menu.
4. Main Menu: Config...\Interfaces...
5. CONFIGURE Interfaces
Highlight Remote.
6. EDIT (F3) to access CONFIGURE Remote Interfaces.
7. Highlight a NET port.
8. CTRL (F4) to access CONFIGURE Set NET Port.