Filter
Top Products
3
8/15/05
Manual No. 701-055M
Land Pride
Assembly Instructions for 4210ST & 4410ST Series Trekers
■
Refer to Figure 6A:
3. Remove the two extension springs from the Bed
Latch Assembly.
4. Remove attaching hardware mounting the Bed Latch
Assembly. Attaching hardware consist of eight
1/4"-20 x 5/8" hex head cap screws, flat washers, hex
flange lock nuts and four latch keeper bars.
Bed Latch U-bolts (Left Side Shown)
Figure 6A
Electric Lift Cylinder Installation
Refer to Figure 7A & Figure 8A:
1. Attach the base of the Electric Bed Lift to the
mounting bracket (see Figure 8A for mounting
bracket location) with a 1/2" x 49/64" clevis pin.
Secure pin with 5/32" cotter pin. The rod end will be
attached to the cargo box later. Secure pin in place
by bending one leg of the cotter pin.
Refer to Figure 8A:
2. Locate the T-shaped connector mounted on the end
of the Treker wiring harness. Cut plastic tie securing
the T-shaped connector to the Treker frame.
Refer to Figure 9A:
3. Plug the T-shaped connector to the Electric Lift
connector.
!
CAUTION!
The cylinder needs to be extended to attach it to the cargo
box. Be very careful not to hit anything while extending the
cylinder causing bodily injury or damage to the vehicle.
!
CAUTION!
Care should be taken when removing the Bed Latch Lock-
Up Arm to prevent injury. Avoid pinch points and make
certain the cargo box does not fall when changing from
Bed Latch Lock-Up Arm to Electric Bed Lift Assembly.
23465
Extension
Spring
Attaching
Hardware
Bed Latch
Assembly
IMPORTANT: The Electric Bed Lift is protected by an
internal clutch in both directions. When the up or
down travel limit is reached, the electric dump will
make a loud “ratchet” noise indicating end of travel
limit has been reached or the Electric Bed Lift is
overloaded. When this noise is heard, release the
switch immediately.
Electric Lift Lower Mounting
Figure 7A
Treker Wiring Harness for the Electric Lift
Figure 8A
T-Shape Connector
Figure 9A
1/2" Clevis Pin
23646
5/32" Cotter Pin
Electric Bed Lift
Electrical End
23644
Mounting
Bracket
Wiring Harness
T-shaped Connector
Treker Wiring
Harness
21175
Wiring Harness
T-shape Connector
Electric Lift
Connector