Filter
Top Products
2
Manual No. 701-055M 8/15/05
Land Pride
Assembly Instructions for 4210ST & 4410ST Series Trekers
■
Refer to Figure 2A:
2. Locate behind the dashboard a green wire with red
connector, green wire with yellow stripe and red
connector and black wire with blue connector. Wires
can be located by looking through the left front fender
well at the dashboard. If unable to locate the wires,
then remove glove box by prying glove box from
dashboard with a screwdriver at its rivet locations.
Once the wires are located, pull them through the
dump mounting panel opening as shown.
Electrical Wiring & Mounting Panels
Figure 2A
Rocker Switch with Electrical Wiring attached
Figure 3A
Refer to Figure 3A:
3. Plug wires to rocker switch terminals as follows:
• Green wire with yellow stripe and red connector labeled
Dump Down to rocker switch top terminal.
• Black wire with blue connector to middle rocker switch
terminal.
• Green wire with red connectorlabeled Dump Up to
rocker switch bottom terminal.
Dump Mounting
Panel Opening
21471
Black Wire With
Blue Connector
Green Wire With
Red Connector
Green Wire With
Yellow Stripe and
21472
Rocker Switch
This End Down
Green Wire With
Red Connector
Labeled Dump Up
Black Wire With
Blue Connector
Green Wire With
Yellow Stripe and
Red Connector
Labeled Dump down
Bottom Terminal
Top
Terminal
• Do not press rocker switch into dump mounting panel
until after electric lift cylinder has been installed and
after correct wiring connections have been verified in
“Final Assembly” on page 5 step 3.
Bed Latch Lock-Up Arm
Figure 4A
Cargo Latch Removal
Refer to Figure 4A:
1. Support the cargo box in the up position with the Bed
Latch Lock-Up Arm.
Refer to Figure 5A:
2. Unbolt and remove the 5/16" U-bolt from the right
and left side of the Treker chassis.
Bed Latch U-bolts (Right Side Shown)
Figure 5A
22481
Bed Latch
Lock-Up Arm
Bed Latch
U-bolt
23644
Electric Lift
Mounting
Brackets