Filter
Top Products
9.15
Section 9
Disassembly
9
Figure 9-56. Removing Dipstick Tube Assembly.
Remove Oil Sentry
™
(If So Equipped)
1. Remove the Oil Sentry
™
switch, from the breather
cover. See Figure 9-57.
Figure 9-57. Removing Oil Sentry
™
Switch.
Remove Breather Cover
1. Remove the four hex. flange screws securing the
breather cover to the crankcase. See Figure 9-58.
2. Carefully pry under the protruding edge of the
breather cover with a screwdriver to separate the
cover. See Figure 9-59. Do not pry on the sealing
surfaces as it could cause damage resulting in
leaks.
Figure 9-59. Prying Off Breather Cover.
3. Remove the cover and the gasket. See
Figure 9-60.
Figure 9-58. Removing Breather Cover Screws.
Figure 9-60. Removing Breather Cover and Gasket.