Filter
Top Products
8.9
Section 8
Electrical System and Components
8
Stator
The stator is mounted on the crankcase behind the
flywheel. Should the stator have to be replaced, follow
the procedures in Section 9 - “Disassembly.”
Rectifier-Regulator
The rectifier-regulator is mounted inside the lower
blower housing. See Figure 8-10. To replace it; remove
the upper blower housing, disconnect the connector
plug, remove the single mounting screw with the
ground lead and lift out the rectifier-regulator.
NOTE: When installing the rectifier-regulator, make
sure the cooling fins are "up", and the
harness wires remain in the channel of the
lower blower housing, with adequate
clearance from the flywheel.
Figure 8-10. Rectifier-Regulator.
Figure 8-11. Connections for Testing Charging System.
DC Voltmeter
(–)
Battery
(+)
Flywheel Stator
Ammeter
Rectifier-Regulator