Kenwood DNX570HD GPS Receiver User Manual


  Open as PDF
of 143
 
120120
Return to the Top page
Remote Controller Operation
Remote control
Thisunitcanbeoperatedusingtheremotecontrol.
ForDNX890HD,DNX7700BT,DNX690HD,andDNX5700BT,theremotecontrolissuppliedwith
theunit.
ForDNX570HD,DNX570TR,andDNX5080EXtheremotecontrolistheoptionalaccessory(KNA-
RCDV331).
2CAUTION
•Put the remote control in a place where it will not move during braking or other operations. A
dangerous situation could result, if the remote control falls down and gets wedged under the pedals
while driving.
•Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat
generation may result.
•Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately
rinse with water and consult a physician.
•Place the battery out of reach of children. In the unlikely event that a child swallows the battery,
immediately consult a physician.
Battery Installation
Iftheremotecontroloperatesonlyovershorterdistancesordoesnotoperateatall,itispossible
thatthebatteriesaredepleted.
Insuchinstances,replacethebothbatterieswithnewones.
1
Insert two “AAA”/“R03”-size batteries with the and poles aligned properly, following
the illustration inside the case.
 previous next