Kenwood DNX570HD GPS Receiver User Manual


  Open as PDF
of 143
 
143
Return to the Top page
Controlling Audio
Equalizer Control
Youcanadjustequalizerbyselectingthe
optimizedsettingforeachcategory.
1
Touch [Equalizer].
Equalizer screen appears.
Ñ
DNN990HD operation
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
[Powerful], [iPod], and [User].
NOTE
•[iPod] is available only during iPod source.
Controlling equalizer manually
TheGraphicEqualizercannotbesetwhen
youselect[iPod]intheEqualizerscreen.
1
Touch [EQ] in the Equalizer screen.
2
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (light green boxed area)
Adjust the gain level by touching the each
frequency bar.
Touching [C], [D], [R] and [S] can also
adjust the level. Use [C] and [D] to select a
frequency, and [R] and [S] to set the level.
EQ INIT
Returns to the previous level which the gain
level is adjusted.
Flat
Tone curve becomes flat.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5 Hz.
Loudness
Set the amounts of boost of low and high
tones. “OFF”, “Low”, “High”
SW Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See Speaker setup (P.139).
 previous next