Assembling The LP Gas Tank Hook
Attach Ihe Pressure Cylinder Holder and Tank
Guide to the Cart Legs-Wheal Side of grill as
shown in Fig. 6. Align the tapped holes of both
parts v4h the holes on Side Panel, Secure firmly
using 4 of the 1/4"xl/2" Phillips head screws and
nuts provided,
Assembling The Grill Drawer
1. Install 2 of the 1/4"xl/2" Phillips head screws
to the rear of the Drawer Track. Without these
screws the drawer will not stop properly.
2. Slide the Drawer into the Drawer Tracks until
it st_os. See Fig. 7.
3. Install 2 of the 1/4"x112" Phillips head screws
to the front of the Drawer Track, This impor-
tant step prevents the drawer from being
pulled outside the tracks. See Fig. 7.
Figure 6
Figure 7
SIDE
TANK GUIDE
PRESSURE
HOLDER
Installing The Grill Head
.
Now that you've assembled the grill cart you
can install the pre-assembled Grill Head. See
Fig. 8. To reduce the weight of the Grill
Head, we suggest you open the Gdll Lid and
remove the packed components. Even with
the components removed, this step requires 2
people to lift and position the Grill Head onto
the grill cart. Be sure to align the 2 holes
beneath the hang ledge on each side of the
Grill Head with the 2 holes on each cross
braoe of cart. Raise Grill Lid and insert 4 ()f
the 1/4"xl-3/8" Phillips head screws and lock
nuts and tighten securely.
2. From the back side of grill head, install the
Grease Draining Tray. See Fig, 8.
3. Center the Grease Receptacle under Grease
Draining Tray. See Fig. 8.
.
Install Rear Wind Shield between both Bowl
Side Panels by using 2 of the 1/4"x1/2"
Phillips head screws provided, See drawing
below.
Figure 8
GRILL HEAD
i
CROSS BRACE =
11
GREASE
RECEPTACLE
. _" GREASE
DEAIN_NG
TRAY
HANG LEDGE