Filter
Top Products
Assembling The Cabinet Doors
1. tnstall Door Stops to Bottom Shelf and Top
Panel of Cabinet. See Fig. 4. Secure firmly
using 4 of the 1/4"x1/2" Phillips head screws
and nuts.
Figure 4
2, If you haven't already done so, remove the
white protective film fi'om the stainless steel
Doors. Attach a Door Handle to each Front
Door using 2 of the M4x6mm Phillips head
screws provided. See Fig. 5. Be careful not to
scratch the door surfaces.
OF CART LEGS
3. When installing the Front Doors, make sure
the door bolt holes are located on the hinge
sides of the Cart Legs.
4. Install either Front Door by inserting 1/4"x5/8"
part-threaded bolt through the lower door bolt
hole of the Front Door and into the tapped
hole of the. Bottom Shelf. Tighten securely.
Next, align the upper door bolt hole of Front
Door with the tapped hole in the Top Panel
of Cabinet. Insert 1!4"x5/8" part-threaded bolt
provided and tighten securely.
Figure 5
BOTTOM
SHELF
5. Repeat these steps to install the other Front Door.
UPPER DOOR
How To Level The Grill Cart So The Doors Line-Up
When the top edge of the cabinet doors do not line-up DOORHANDLE
your grill cart needs to be leveled. This step is often
required after initial assembly and when your grillhas
been moved to a new location. To level your grill cart,
use an 11/16" open-end wrench to unscrew either
front or rear Castor counterclockwise from its Castor
Seat (see bottom of the Cart Leg) until the cabinet
doors are aligned. See Fig. 5.
TAPPED HOLE
FRONT DOOR
LOWER DOOR
BOLT HOLE
TOP PANEL
OF CABINET
10