Filter
Top Products
37
ENGLISH
Checking the information of the navigation system
• If the rear view screen is displayed when shifting
the gear to the reverse (R) position, the reverse
gear signal is detected (<On>).
w Information service being received
(Traffic or Area information; only for KW-NT500HDT)
*
1
About calibration
The calibration is a function conducted in order to
display the current position more accurately using
signals from GPS and the internal sensors.
Even after calibration status changed to
<Learned>, the system will keep learning to make
the current position more accurate.
• The calibration does not function without the
connection of GPS antenna and the speed signal
lead. For the connection, ☞ Installation/Connection
Manual (separate volume).
• Driving under various conditions completes the
calibration faster. If <Learning> remains on the
screen for a long period, check the connection of the
GPS antenna and the speed signal lead.
• While learning is going on, the current position may
not be displayed correctly .
1 Version of the software
2 Version of the map database
3 Serial number
4 Speed pulse rate
5 GPS antenna connection status
<OK>: GPS antenna is detected (the figure
shows the number of GPS satellites being
received).
<NG>: GPS antenna is not detected
6 Status of the gyroscope
7 Status of calibration *
1
<Learning>: The system has started learning
calibration data.
<Learned>: Though learning is almost complete,
the system is still learning to make the calibration
data more accurate.
8 Resets the calibration data.
Reset the data if you replace the tires or if the
current position is displayed far from the actual
position
9 Connection status of the illumination control lead
<On>: The illumination signal is detected.
p Connection status of the parking brake lead
<On>: The parking brake is engaged.
q Connection status of the reverse gear signal lead
<On>: Reverse gear signal is detected.
System Info
1 Press - <Settings>.
2
1
2
3
Sensor Status
1 Press - <Settings>.
2
9
4
5
6
7
p
q
8
w