Filter
Top Products
Voice activation 23
Voice command descriptions (continued)
Navigation commands (where fitted)
• [NAVIGATION] SHOW DESTINATION
This shows the destination of the route currently set in the
navigation system. The destination address is displayed at
the top of the screen.
• [NAVIGATION] SHOW [CURRENT] POSITION
This shows the vehicle's current position in the centre of the
screen. This is equivalent to pressing the NAV key on the
navigation screen.
• [NAVIGATION] SHOW [COMPLETE/ENTIRE/WHOLE]
ROUTE
This shows the whole route currently set in the navigation
system.
• [NAVIGATION] SHOW NORTH UP
This will orient the map display to have North heading
towards the top of the screen.
• [NAVIGATION] SHOW (HEAD/HEADING) UP
This will orient the map display to have the vehicle heading
towards the top of the screen. This command is available
when the navigation is showing a detailed map with a scale
between zoom levels 1 to 8, or
1
/
32
mile to 2 miles, or 50m
to 8km. This command is not available if the map display
has been scrolled away from the current position.
• [NAVIGATION] ZOOM IN (MAX/MAXIMUM)
This will adjust the screen display to show maximum
magnification.
• [NAVIGATION] ZOOM OUT (MAX/MAXIMUM)
This will adjust the screen display to show minimum
magnification.
• [NAVIGATION] [SELECT] ROUTE HOME
This sets a route to the "home" location, if it is defined in the
navigation system. The user will be asked to confirm the
command before the route is set.
•[NAVIGATION] REROUTE
This will force a manual re-calculation of the route based
upon the current position of the vehicle. This can be used
when starting a route from an un-mapped area and the
nearest road selected by the navigation system is not the
road used to exit the un-mapped area. The user will be
asked to confirm the command before the route is
recalculated.