Filter
Top Products
SKU 02948 For technical questions, please call 1-800-444-3353. Page 7
LUG NUT
(9)
CAP (A9)
CASTLE NUT (11)
BEARINGS (A9)
LUG NUT (9)
HUB (A9)
TIRE & RIM (A15)
FIGURE A
FLAT WASHER (A9)
COTTER PIN (10)
AXLE (A8)
Carefully slide the Hubs (A9) over the Spindles at each end of the Axle (A8). Insert
the Bearings (A9) and the Flat Washer (A9) on the Spindles. Screw a Castle Nut
(11) tightly onto each Spindle. Then back the Castle Nuts off slightly so that the
Hubs can just move freely. (See Figure A)
Place a Tire w/Rim (A15) on each Hub (A9). Secure the Tire w/Rims to the Hubs,
using four Lug Nuts (A9) per Tire. NOTE: Make sure to tighten (torque) the Lug
Nuts to at least 90 ft-lb. (See Figure A.)
Insert an Cotter Pin (A9) through the hole at the end of each Spindle of the Axle
(A8) and spread the Cotter pin. (See Figure A.)
Fill the Caps (A9) with bearing grease. Then, press each Cap onto the Hubs (A9).
(See Figure A.)
8.
9.
10.
11.
REV 05b