Filter
Top Products
SKU 02948 For technical questions, please call 1-800-444-3353. Page 12
OPERATING INSTRUCTIONS
Only use a 1-7/8” ball hitch (not included) on the towing vehicle. (See Figure F.)
NOTE: To reduce friction between the hitch ball
and Hitch Coupler (A14), apply a layer of heavy
weight grease over the hitch ball.
(See Figure F.)
1.
2.
CAUTION
Care must be taken when backing up
the Trailer; only back up the trailer on a
straight path. If the Trailer is allowed to turn
off the straight path while backing up, the Trailer
could jackknife, causing severe damage to the
trailer and to the towing vehicle.
CAUTION
Care must be taken when backing up
the Trailer; only back up the trailer on a
straight path. If the Trailer is allowed to turn
off the straight path while backing up, the Trailer
could jackknife, causing severe damage to the
trailer and to the towing vehicle.
REV 05f
TAIL GATE (A6)
LOCK HANDLE
LOCK HANDLE
LEFT
SIDE
PANEL
(A2)
RIGHT
SIDE
PANEL
(A3)
PRONG PRONG
FRAME
MOUNTING SLOT
FRAME
MOUNTING SLOT
FRAME (A1)
FIGURE E
Raise the Lock Handles on the rear of the Left Side Panel (A2) and Right Side
Panel (A3). Insert the Tail Gate between the Left Side Panel and Right Side Panel.
Make sure the two Prongs at the bottom of the Tail Gate are inserted into the two
Mounting Slots in the rear of the Frame (A1). Then, lower the Lock Handles to lock
the Tail Gate in position. (See Figure E.)
6.