Filter
Top Products
SKU 02948 For technical questions, please call 1-800-444-3353. Page 10
To Attach the Tail Light Bracket:
Align the two mounting holes in a Tail Light Bracket (A7) with the two mounting holes
located in the side, rear section of the Frame (A1). Then secure the Tail Light Bracket
to the Frame, using two Bolts, two Spring Washers, and two Nuts (3). Repeat this
procedure to attach the remaining Tail Light Bracket to the other side of the Frame.
(See Assy. Diagram.)
To Attach the Tail Light/Wire Set:
See Wiring Diagram on page 15. Position a Tail Light (A11) to the front of a Tail
Light Bracket (A7), making sure the red plastic lenses face to the rear of the Trailer
and outward from the side. Insert the two threaded mounting bolts of a Tail Light
through the mounting holes located in the Tail Light Bracket. Then secure the Tail
Light to the Tail Light Bracket, using two Spring Washers, and two Lock Nuts (3).
Repeat this procedure to attach the remaining Tail Light to the other Tail Light Bracket.
(See Assy. Diagram.)
UNDERSIDE OF BOX TRAILER
TRAILER
FRAME
(A1)
LEFT SIDE BRACE (A17)
RIGHT SIDE BRACE (A18)
TOW BAR (A13)
WIRE HARNESS (A11)
TAIL LIGHT (A11)
FIGURE D
With assistance, carefully tip the Trailer on its side to perform this procedure. NOTE:
It is recommended to use heavy gauge, nylon, tie strips (not included) to attach the
wiring harnesses of the Tail Lights (A11) to the underside of the Frame Assembly.
Once finished, carefully tip the Trailer to its upright position. (See Figure D.)
1.
2.
3.
REV 03d