Filter
Top Products
You may have an air inflator kit that is located in the
glove compartment. It includes a 22 ft (6.7 m) hose with
three nozzle adapters.
To use the accessory inflator, do the following:
1. Attach the appropriate nozzle adapter to the end of
the hose if required.
2. Attach that end of the hose to the object you wish
to inflate.
3. Attach the other end of the hose to the outlet.
4. Press and release the switch to turn the air inflator
on. The indicator light will remain on when the
inflator is running.
The system has an internal clock to prevent
overheating. The system will allow about five
minutes of running time, then the compressor will
stop. The indicator light will then begin to flash.
When the indicator is off, the inflator can be started
again by pressing the switch. If the compressor
is still hot, it may only run for a short time before
shutting off again.
5. Press and release the switch to turn the inflator off.
Place the inflator kit tools in the pouch and store it in its
proper location. Remove the inflator hose from the
outlet during loading and unloading. Load leveling will
not function with the inflator hose attached to the inflator
outlet. See “Electronically Controlled Air Suspension
System” under Loading Your Vehicle on page 4-43.
To reinstall the cover, line up the tabs at the back of the
cover, put it in place and latch the tabs.
A continuous flashing indicator light may also indicate a
malfunction in the air suspension system. See
“Electronically Controlled Air Suspension System” under
Loading Your Vehicle on page 4-43 for more information.
{CAUTION:
Inflating something too much can make it
explode, and you or others could be injured.
Be sure to read the inflator instructions, and
inflate any object only to its recommended
pressure.
5-70