Filter
Top Products
Reprogramming a Single
HomeLink
®
Button
To program a device to HomeLink
®
using a HomeLink
®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
®
button.
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
®
button, proceed with Step 2 under “Programming
HomeLink
®
” shown earlier in this section.
Resetting Defaults
To reset HomeLink
®
to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
®
at 1-800-355-3515, or on the Internet at
www.homelink.com.
Storage Areas
Glove Box
Open the glove box by pulling the side of the handle
towards the driver’s side.
Overhead Console
The overhead console includes reading lamps and a
HomeLink
®
transmitter.
The midgate window (B), power roof (C) and rear tailgate
window (D) switches are located in the overhead console.
See Midgate on page 2-13, Power Roof on page 2-18
and Tailgate on page 2-14 for more information.
The sunroof switch (A) (if equipped) is also located in
the overhead console. See Sunroof on page 2-62 for
more information.
2-58