Filter
Top Products
6. Select the Map screen button after entering the
destination.
7. Select the Mark screen button from the map. The
address book screen appears. Five preset
destinations can be stored, but you must set them
from the Address Book screen. There are other ways
to get to the Address Book as well.
8. Select the Name screen button. An alpha-keyboard
displays. Enter the name. If you have stored the
location with a name automatically assigned by the
system, use the “BACKSPACE” button (not “BACK”)
to erase the letters and begin typing your preferred
title for this destination. For example, choosing a
destination by address and storing it to the Address
Book will store the actual address, which may not be
easy to display in a short Preset button that has
8 digits, so name it something shorter.
9. Press and hold one of the screen buttons at the
bottom of the screen until the name appears in the
screen button on the display. A beep may be heard.
The name appears in that preset destination screen
button and is now available to select from the
Destination Entry screen. See “Using Your Stored
Preset Destinations” next in this section to select
it as a destination.
See “Adding or Changing Preset Destinations”
under Destination on page 2-13 for more information
on how to add preset destinations.
Using Your Stored Preset Destinations
These destinations are available for selection while
driving.
1. If the radio is on with a map disc inserted, skip to
Step 5.
2. Press
O to turn the system on.
3. Insert the DVD map disc. See “Installing the Map
DVD” under Maps on page 2-4 for more information.
4. A caution may appear. Select the OK screen button
to proceed.
5. Press the DEST hard key.
6. Select one of the available preset destination
screen buttons. A map screen, with the destination
marked, appears and the system immediately
begins to route to that destination.
The preset destination buttons overwrite and
provides guidance to the selected destination even
if the guidance is in place. Pressing a preset
destination cancels the current route and then,
routes to the single preset destination.
If more waypoints or stops are desired after the
preset is used, follow the adding stopover method
to load a total of four additional waypoints.
1-11