Filter
Top Products
You can store and operate your garage door opener in
the third compartment of your overhead console. To
install your garage door opener, follow these instructions:
1. Open the compartment by pressing the latch forward.
2. Remove the garage door opener button, by
pressing the tabs and pulling it down.
3. Remove the piece of self-sticking hook and loop
fastener from the top of the garage door opener
compartment.
4. Peel the protective backing from the hook and loop
fastener and press it firmly to the back of your
garage door opener.
5. Line up the button on the garage door opener with
the opening in the storage compartment door. Make
sure the garage door opener button is facing
down and then press the opener firmly into the
garage door opener compartment.
6. Once the opener is installed, remove the three pegs
from the garage door opener button. Each peg is a
different size.
7. Put the garage door opener button back in by
inserting the tabs into the slot in the garage
door opener compartment.
8. Press the button on the garage door storage
compartment. If your garage door opener does not
work you will need to change the pegs until it does.
2-35