Filter
Top Products
2. Depress buttons in the Control Housing
stem and slide on the Upper Stem (see
Image B above).
3. Depress the buttons in the Lower Stem
and insert it into the Upper Stem. Buttons
will pop into the holes, and you can
achieve the desired stem length. The third
set of holes from the end is most com-
monly used.
4. As shown
(see Image C on follow-
ing page), wrap searchcoil cable securely
around stem and connect to detector.
The first cable turn goes over the top
of the stem. The cable should be snug
but still slightly loose so that the angle
Graphic Target Imaging 1500 - 11
Image A Image B