Filter
Top Products
nüvi 680 Owner’s Manual 43
aPPendix
Mounting on Your
Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard and
comply with certain state regulations.
CAUTION: The permanent
mounting adhesive is extremely
difcult to remove after it is installed.
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover from
the top of the disk.
5. Place the suction cup mount on top of
the disk. Flip the lever down (toward
the disk).
Disk
Suction
cup mount
Suction
lever
Changing the Fuse
CAUTION: When replacing the
fuse, do not lose any of the small
pieces and make sure they are put
back in the proper place.
If your unit will not charge in your
vehicle, you may need to replace the
fuse located at the tip of the vehicle
adapter.
1. Unscrew the black,
round end piece and
remove it.
2. Remove the fuse
(glass and silver
cylinder) and replace
with a 3A fast blow
fuse.
3. Ensure that the silver
tip is placed in the
black end piece.
Screw on the black
end piece.
UnscrewUnscrew
end
piece
silver tip
fuse
end
piece
silver tip
fuse