Filter
Top Products
29
Getting Started
29
Reference
Setup Map — ‘Map’ Tab
The ‘Map’ Tab contains settings for the Basemap, MapSource, Lat Lon
Grids, and Grid Labels. To change a setting, highlight the appropriate
fi eld then press ENTER. Make your new selection then press
ENTER to accept the selection.
MapSource —
This option allows you to turn map data displayed on the
map ‘On’ or ‘Off’. This setting controls factory-loaded data as well as any
MapSource data that may be loaded in the unit.
Lat Lon Grid —
Lat Lon Grids will be displayed in smaller increments as the
Zoom Level on the Map Page is decreased. The ‘Zoom’ setting for this option
determines when the grids will begin displaying on the Map Page.
If you select ‘Auto’, and have the MapSource options set to ‘ON’, the unit will
not display a Lat Lon Grid.
Grid Labels —
This option allows you to display the coordinates on the grid.
You must have the ‘Lat Lon Grid’ displayed for ‘Grid Labels’ to be displayed.
If you select ‘Auto’, and have the MapSource options set to ‘ON’, the unit will
not display Grid Labels.
Setup Map — ‘Waypoint’ Tab
The ‘Waypoint Tab contains the Waypoints, and Active Route Waypoint
option settings. Each of the options has a ‘Text’ and ‘Zoom’ setting. To change
a setting, highlight the appropriate fi eld then press ENTER. Make your new
selection, then press ENTER to accept the selection.
Waypoints —
This option sets the display parameters for all waypoints.
Setup Map — ‘Map’ Tab
Map Page Options
190-00229-00.indd 07/25/01, 11:22 AM29