Filter
Top Products
Garmin G1000 Cockpit Reference Guide for the DA42-L360
190-01062-01 Rev. A
51
Abnormal Operation
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
ABNORMAL OPERATION
REVERSIONARY MODE
Should a system detected failure occur in either display, the G1000 automatically
enters reversionary mode. In reversionary mode, critical flight instrumentation is
combined with engine instrumentation on the remaining display.
Reversionary display mode can be manually activated by pressing the DISPLAY
BACKUP Button on the audio panel.
NOTE: The Diamond DA42-L360 Pilot’s Operating Handbook (POH) always
takes precedence over the information found in this section.
ABNORMAL COM OPERATION
When a COM tuning failure is detected by the system, the emergency frequency
(121.500 MHz) is automatically loaded into the active frequency field of the COM
radio for which the tuning failure was detected.
HAZARD DISPLAYS WITH LOSS OF GPS POSITION
If GPS position is lost, or becomes invalid, selected hazards being displayed on the
Navigation Map Page are removed until GPS position is again established.
Loss of Hazard Functions with Loss of GPS
Position