Filter
Top Products
zūmo 200 Series Owner’s Manual
Getting Started
Installing the Handlebar Base
The zūmo includes parts for two
handlebar installation solutions. Custom
mounts can require additional hardware
(www.ram-mount.com).
Installing the U-bolt and handlebar
base:
1. Place the U‑bolt around the
handlebar, and thread the ends
through the handlebar base.
2. Tighten the nuts to secure the base.
Do not overtighten.
NOTE: The recommended torque is 50
lbf-in. Do not exceed torque of 80 lbf-in.
Handlebar
base
Handlebar
U-bolt
Installing the handlebar base to the
clutch/brake clamp bracket:
NOTE: Both 1/4 in. standard and M6
bolts are included. Match the size of the
factory bolts on your clutch/brake clamp
bracket.
1. Remove the two factory bolts on your
clutch/brake clamp bracket.
2. Thread the new bolts through the
handlebar base, spacers, and clamp
bracket.
3. Tighten the bolts to secure the base.
Clutch/brake
clamp bracket
Handlebar
base
Spacers