Filter
Top Products
1. OPERATIONAL OVERVIEW
1-13
1.5.4 Selecting image source
When more than one network radar or network sounder is connected to the
equipment, you may select an image source for each as shown below. This is
not necessary when only one network radar or network sounder is connected.
1. Press the [DISP] key.
2. Press any soft key to show the following display.
RADAR SOURCE
RADAR
- - -
SOUNDER SOURCE
SOUNDER
-
IP APPRESS
172. 031. 003. 002
HOST NAME
RADAR - - -
▲
SELECT
SOURCE
EDIT
RETURN
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
Select source menu
3. Use the trackball to select RADAR SOURCE or SOUNDER SOURCE as
appropriate, then press the EDIT key.
RADAR SOURCE SOUNDER SOURCE
Radar source Sounder source
RADAR
- - -
SOUNDER
-
Radar source and sounder source windows
4. Adjust the trackball to select location and rotate the [ENTER] knob to set
character.
5. Push the [ENTER] knob to set.
6. Press the [DISP] key to finish.
7. Turn the power off and on again.
Note: Source names are determined at installation. For example, the source
names for radars in a two radar system might be “RADAR” and
“RADAR1”.