Filter
Top Products
1-2
1.2 Inserting Mini Chart Card
Insert appropriate mini chart card before turn-
ing on the power.
1. Push down the lid catch to open the mini
chart card slot cover.
Card slot
Figure 1-2 Location of mini chart
card slot cover
2. Insert appropriate mini chart card groove
side up.
3. Close the slot cover to protect the chart
drive. (Keep the slot cover closed at all
times.)
Note: Turn off power before inserting or eject-
ing the mini chart card.
1.3 Turning the Power On/Off
Press the [POWER/BRILL] key at bottom left-
hand side of the display unit to turn on the
power. When the unit is turned on, it proceeds
in the sequence shown in Figure 1-3, after
displaying the FURUNO information display.
Displayed for about five seconds.
Displayed for about 30 seconds,
or press any key to escape.
The last-used display appears.
NO NATIONAL HYDROGRAPHIC OFFICE
HAS VERIFIED THE INFORMATION
IN THIS COASTLINE DATA CARD AND
NONE ACCEPT LIABILITY FOR THE
ACCURACY OF REPRODUCTION OR ANY
MODIFICATIONS MADE THEREAFTER.
THIS PRODUCT WITH THIS COASTLINE
DATA CARD DOES NOT REPLACE THE
REQUIREMENT TO USE THE
APPROPRIATE PRODUCTS FOR
NAVIGATION ACCORDING TO NATIONAL
AND INTERNATIONAL REGULATONS.
— — WARNING — —
FURUNO ELECTRIC CO., LTD.
PROGRAM OK
RAM OK
BACKUP DATA OK
INTERNAL BATTERY OK
GPS OK
START UP TEST
Figure 1-3 Start-up sequence
Your equipment takes about 90 seconds to
find its position when turned on for the very
first time. This is because the equipment has
no satellite data, called the Almanac, in its
database. If you want to lessen the time
needed to find position you may enter your
position manually (default position: San Fran-
cisco, USA) on the GPS SETUP OPTIONS
menu.
Thereafter it takes about 12 seconds to find
position each time the power is turned on.
When the satellite signal is being received
normally, the equipment displays various ab-
breviations at the bottom left-hand corner of
the display which show DGPS/GPS receiver
status. Table 1-1 shows these abbreviations
and their meanings.
Table 1-1 Display abbreviations
noitacidnIgninaeM
D2SPGD2lamroN
SPG)noisnemid(
xifnoitisop
D3SPGSPGD3lamroN
xifnoitisop
D2SPGD
)D0561-PG(
laitnereffidD2lamroN
xifnoitisopSPG
D3SPGD
)D0561-PG(
laitnereffidD3lamroN
xifnoitisopSPG
XIFONebtonnacnoitisoP
.dnuof
PODrorrePOD
OMEDedomnoitalumiS
Turning the power off
Press and hold down the [POWER/BRILL]
key until the screen goes blank. The time
remaining until the power is turned off is
shown on the screen.