Filter
Top Products
Instrument Panel Controls
77
[IP02150(ALL)08/95]
S (Panel and Floor)
[IP02200(ALL)03/95]
Select S to direct airflow to the floor and through the
instrument panel registers at the same time. This selection can
be used to either heat or cool your vehicle. The air conditioner
will operate to cool the air if the outside temperature is about
50˚F (10˚C) or warmer.
*
[IP02250(ALL)08/95]
R (Floor)
[IP02300(ALL)03/95]
Select R to direct air to the floor. The air cannot be cooled in
the R position but can be heated by rotating the temperature
knob into the red area.
[IP02350(ALL)08/95]
P (Floor and Defrost)
[IP02400(ALL)03/95]
Select P to direct air to the floor and windshield defrosters at
the same time. If the outside temperature is about 50˚F (10˚C)
or warmer, the air will also be dehumidified to remove
moisture. This feature will help prevent fogging in humid
weather. The air can be cooled or heated.
%
*
[IP02450(ALL)08/95]
V (Defrost)
[IP02500(ALL)03/95]
Select V to obtain maximum airflow to the windshield. Rotate
the temperature knob into the red area for the air temperature
required to defrost. When the outside temperature is about 50˚F
(10˚C) or warmer, the air will be dehumidified to remove
moisture. Rotate the
H
knob to increase the airflow.
*
[IP02550(ALL)04/95]
Operating tips
*
[IP02600(ALL)02/95]
The following tips will help you to get the most satisfaction
from your air conditioning and heater system.
[IP02650(ALL)03/95]
■ In humid weather, select V before starting your engine.
This will help to prevent windshield fogging. After a few
minutes of operation, you may select another function.
[IP02700(ALL)03/95]
■ To prevent humidity buildup inside your vehicle, always
drive with the air conditioner or heater system turned on.
File:06unipr.ex
Update:Wed May 1 13:46:22 1996