![](http://pdfasset.owneriq.net/c/a5/ca5ef3b2-8c7d-4222-ab76-1bea0f165eba/ca5ef3b2-8c7d-4222-ab76-1bea0f165eba-bg9.png)
C3493pr-0921
9
BATTERY CHARGING
F
C3493pr-0921
E
Battery
Connector
Charger
Connector
A
B
• Plug the charger connector into the battery connector
A
.
• Plug the charger into a standard wall outlet
B
.
Note: If power flow to the wall outlet is controlled by a switch, make
sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the battery connector from
the charger connector. Unplug the charger from the wall outlet. The
battery is now ready to be installed in your vehicle. Please see the
Battery Installation section on page 20 for detailed instructions on
installing your battery. If your battery is already installed in your
vehicle, simply re-connect the motor harness connector to the battery.
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery, or
help in assembly of the vehicle.
ASSEMBLY
• Place a .437 cap nut on a flat surface, inside up.
• Fit the end of the rear axle into the cap nut.
• Tap the opposite end of the rear axle with a hammer to secure the
cap nut on the rear axle. Pull on the cap nut to be sure it’s secure.
Rear Axle
.437 Cap Nut
1
.437"