Filter
Top Products
Assembly
• With the Power Wheels
®
logo facing out, insert a roll
cage into a groove in the topside of the vehicle body.
• Push down firmly on the roll cage to "snap" it into place.
• Pull up on the roll cage to be sure it is secure.
• Repeat this procedure to assemble the other roll cage to
the vehicle body.
F
Roll Cage
Vehicle Body
• Turn the vehicle body upside down so that the bottom
faces you.
• Fit the crossbar into the groove near the back end of the
vehicle body.
Hint:You may need to adjust the steering linkage slightly to
fit the crossbar into the groove.
• Fit the short end of a rear axle through the hole in the
steering linkage, crossbar and the vehicle body.
• Push the rear axle down until the long end fits into the
groove in the steering linkage.
Hint: You may need to tap the rear axle with a hammer to
completely fit the long end of the rear axle into the groove
in the steering linkage.
Groove
Crossbar
Rear Axle
Crossbar
Groove
Steering
Linkage
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle’s unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
WARNING
Logo
Short End
Back View
Back View
Steering
Linkage
9
1
2
3