Filter
Top Products
Battery Charging
• Lift the tab on the back of the seat back to unlatch the
peg from the hole in the vehicle body.
Hint: This may require a lot of force.
• Remove the seat back from the vehicle body.
Seat Back
Tab
• While pushing the battery clamp, remove the battery
from the vehicle body.
• Plug the charger into a standard wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first time use, charge the batteries for
at least 18 hours. Never charge the batteries longer
than 30 hours.
• Recharge the batteries for at least 14 hours after
each use of your vehicle.
• Once the batteries are charged, disconnect the charger
connector from the battery connector. Unplug the
charger from the wall outlet. The battery is now
ready to be installed in your vehicle.
®
IMPORTANT! The battery must be removed from your vehicle for the initial charge in order to complete assembly.
After assembly is complete, you do not need to remove the battery from your vehicle to recharge it.
Battery Clamp
Battery
• Plug the battery connector and charger connector
together. Push firmly to make sure the two connectors
are completely joined.
Gap
No Gap
Incorrect
Correct
PUSH
2
1
3
4
8