Filter
Top Products
8 DOC,F20,EDN Rev.: -
2.1 Mechanical Installation - Rotary
Actuators
The positioner is mounted on to the top surface of the pneu-
matic actuator using an appropriate mounting kit.
The positioner’s mounting configuration is to the VDE/VDI 3845
standard, if the actuator is to the same standard, a standard
NAMUR mounting kit can be used, otherwise a special
mounting kit will have to be obtained.
Assuming the installation will use the standard NAMUR
mounting kit, proceed as follows:
1. Fix the bracket to the top surface of the actuator using the 4
screws provided.
2. Locate the positioner in place on top of the bracket, making
sure that the 4 mm. tongue locates properly into it’s slot in
the actuator spindle.
3. Fix the positioner to the bracket using the 4 screws pro-
vided.
2.0
2.0 Installation - Rotary Actuators / Einbau Drehantriebe / Montage op roterende
aandrijvingen