Filter
Top Products
134. Use a flat head screwdriver to pop off the bearing
cover on the alternator pulley. ‘05-’08 applications should
use the supplied tool with an impact wrench to remove
the stock pulley. ‘09 and later applications should use a
24mm allen tool with an impact wrench.
135. Install the new alternator pulley with the nut
supplied in hardware bag #3 (with kit #15805 for ‘09
Mustangs) and blue Loctite.
136. Attach the stock protective boot to the new
alternator power wire and fasten it to the alternator
terminal with a 10mm socket. Route the wire around the
back of the engine towards the battery, then attach the
new alternator control wiring harness connector from the
TPS/Alternator extension harness to the alternator.
130. Place the tensioner in a cloth wrapped vice and use
a grinding wheel or hacksaw to remove the stop.
131. Use a grinding wheel or file to ensure that the area
that was ground down is smooth and free of burrs.
132. Use a 10mm socket to install the three tensioner
brace bolts, making sure to line up the square holes.
133. Use a 10mm socket to reinstall the tensioner.
©2009 Edelbrock Corporation
Catalog #1580
Brochure #63-1580
Rev. 2/09 - AJ/mc
Edelbrock 4.6L Ford Supercharger System
for 2005 and later Mustang GTs
Installation Instructions
Page 23