Filter
Top Products
55. Hang the water pump on the passenger side outer
bumper bolts while pushing the outlet hose onto the inlet
nipple of the heat exchanger. Secure the hose with a
clamp, and the water pump bracket with two of the M8
flange nuts supplied.
56. Install the long 3/4” hose onto the driver side barb of
the heat exchanger and secure it with a clamp.
VII. Wiring
57. Locate the large multi-pin connector (C110) secured
to the driver side of the PCM bracket. This connector has
12 pins in ‘05 Mustangs, while ‘06 and later cars have a
16-pin connector in this location.
58. Seperate the harness connectors. ‘05 and ‘06
applications should trim enough electrical tape from the
harness behind the chassis side connector (closest to the
radiator) to pull out 2” of wire from the convoluted tubing.
‘07 and later applications will trim the electrical tape from
behind the engine connector (closest to the firewall) to
pull out 2” of wire from the convoluted tubing.
Chassis Side for Engine Side for
‘05 & ‘06 Mustangs ‘07 & Later Mustangs
©2009 Edelbrock Corporation
Catalog #1580
Brochure #63-1580
Rev. 2/09 - AJ/mc
Edelbrock 4.6L Ford Supercharger System
for 2005 and later Mustang GTs
Installation Instructions
Page 13
48. Disconnect the upper radiator hose from the
thermostat housing and radiator, then set it aside.
49. Remove and save the thermostat, its housing and the
o-ring for later reuse.
50. Unbolt and remove the water crossover from the front
of the engine block and unclip the heater hose from the
bottom. Save the o-ring seals for later reuse.
VI. Installing Intercooler Accessories
51. Replace the two upper inside bumper bolts with the
two M8 x 30mm long hex flange bolts included in
hardware bag #5.
52. Replace both outer bumper bolts on the passenger
side with the two M8 x 30mm hex flange bolts supplied in
hardware bag #5.
53. Hang the heat exchanger behind the bumper
reinforcement on the inner bumper bolts replaced in step
52 and secure it with the four M8 flange nuts supplied in
hardware bag #5.
54. Install the supplied 5” piece of 3/4” hose onto the
outlet of the intercooler water pump, secure it with the
supplied hose clamp, then slide a second clamp onto the
hose to secure it on the heat exchanger.