Filter
Top Products
8
When armed, your vehicle is protected as follows:
z
The LED will flash as a visible theft deterrent.
z
Light impacts will trigger the Warning Zone signal. When
triggered, the siren will sound for a few seconds.
z
Heavy impacts will trigger the system. The triggered
sequence is 30, 60, or 90 seconds of constant siren sound-
ing and flashing parking lights.
z
If a protected entry (door, hood, or trunk) is opened, the sys-
tem will immediately trigger the siren and flash the parking
lights. If any vehicle glass is broken the system will immedi-
ately trigger the siren and flash the lights.
disarming
To disarm the system, press . You will hear a chirp and the park-
ing lights will flash once. If the power locks are connected to the sys-
tem, the doors will unlock. If the siren chirps three times when disarm-
ing, refer to the Diagnostics section of this guide. This is called Tamper
Alert. If the siren is active when the system is disarmed you will hear
two chirps but the system is not disarmed. (Refer to the Remote Siren
Silencing section of this guide.) However, if the alarm completes the full
trigger cycle when disarmed you will hear three chirps.
disarming without a remote
This feature allows you to disarm the system without the remote should
it be lost, damaged, or disabled. In order to disarm without a remote,
you must have the vehicle’s ignition key, know where the PlainView 2
Valet
®
button is located, and have the PIN code. Be sure to check with