Filter
Top Products
© 2003 directed electronics, inc.
27
two times followed by a pause and then flash three times followed by a pause.
NNOOTTEE::
The Warn Away
®
response does not report on the LED.
The Long Term Event History will exit if the ignition is turned off or there is no activity
for 60-seconds.
rapid resume logic
The current state of the alarm will be stored in non-volatile memory. If power is lost
and then reconnected, the system will recall the stored state from memory (arm, dis-
arm, and Valet
®
mode).
high security disarm
If the system is armed and triggered and either the lock or unlock button on the fac-
tory remote are pressed within 5-seconds, the alarm will cease horn output. The horn
will chirp once for Arm if the lock button was pressed. The horn will chirp four times
for Disarm if the unlock button was pressed. If the lock or unlock button is used after
the 5-second period during a system alarm, the horn will silence, but the system will
remain in the armed state (there will be no horn honk).
feature programming
The feature programming routine is used to access and change any of the feature set-
tings in the two menus below. The feature settings can be accessed and changed by
using one of the following:
z
The integrated LED/Valet
®
switch to enter the feature programming routine.
z
Use the Directed Electronics Bitwriter
®.
NNOOTTEE::
If Feature Programming Lockout is set to ON, all features will be locked and
can only be accessed by using a Bitwriter
®
.