Filter
Top Products
21
©
1999 Directed Electronics, Inc.
Quick Reference Operating Card
To arm the system using your transmitter
■ Press for one second to arm the system and lock the doors (if the
door locks are connected to the system). When the system arms, you will
hear one chirp and the parking lights will flash once.
To disarm the system using your transmitter
■ Press to disarm the system and unlock the doors (if the door locks
are connected to the system). When the system disarms, you will hear
two chirps and the parking lights will flash twice.
Disarming without a transmitter
■ To disarm without a transmitter, you must have the vehicle’s ignition key
and know where the Valet switch is. (Contact your installer for both the
location and the preset number of presses required for the Valet switch).
Turn on the ignition key. Press the Valet switch the pre-programmed num-
ber of times within 15 seconds. If the system does not disarm, you may
have waited too long; turn the ignition off and repeat the process.
To enter or exit Valet Mode
■ To enter or exit Valet Mode, turn the ignition key on and then off. Then
press and release the Valet switch within 10 seconds. The status LED will
light steadily if you are entering Valet Mode and will turn off if you are
exiting Valet Mode.
To activate Panic Mode
■ Press and hold for 1.5 seconds.
To exit Panic Mode
■ Press , , or .
To activate Silent
®
Mode
■ Press briefly before arming or disarming. The confirmation chirp(s)
will be eliminated for that one operation only.
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂✂
✂✂