Filter
Top Products
9
©
1999 Directed Electronics, Inc.
This feature allows you to disarm the security system without the
remote transmitter, in case that the transmitter is lost, damaged or
disabled. To disarm the system without a transmitter, you must have
the vehicle’s ignition key and know where the Valet switch is located.
Be sure to check with your installer at the time of installation for
both the location and the preset response (1-5 presses) of the
Valet switch.
To disarm the system, turn the ignition
key on and press the Valet switch the
preset number of times within 15 sec-
onds. If the security system does not
disarm, you may have waited too long;
turn the ignition off and repeat the
process.
IMPORTANT: The Valet switch can be programmed to respond to 1-5
presses for the disarm function. You must check with the installer to ver-
ify the programming for your individual unit.
LOCATION OF VALET SWITCH_____________________________
Use Silent Mode to temporarily turn off the arming or disarming chirps
by briefly pressing before either arming or disarming. The con-
firmation chirp(s) will be eliminated for that one operation only.
To permanently turn off the arming and disarming chirps, contact
your dealer.
Silent Mode
DRW-35
Disarming Without a Transmitter