Filter
Top Products
26
© 2005 directed electronics, all rights reserved
user selectable features descriptions - column two
set pin code
z
This feature allows you to change your personal PIN code.
For more information, please refer to the PIN Programming
section of this guide. Factory default PIN number is 2.
select siren sounds
This feature allows you to select which siren sounds will be played back
when the alarm is triggered. Use the following procedure to set this
feature:
1. Enter the feature.
2. Press the button of the remote to begin the playing
of siren sounds.
3. Siren will generate each sound for 5-seconds. There are 6 in
total.
4. To add the sound press the button on the Valet switch
while that sound is playing.
5. To delete the sound press the button on the Valet
switch while that sound is playing.
nnoottee::
After selecting or deleting a sound the siren will immediately play the next
sound. If no sounds are selected by pressing the or button the system
will remain in its previous setting.
NPC
®
on/off
Nuisance Prevention
®
Circuitry (NPC
®
) stops repeated triggering of the
same zone. If one zone is triggered three times in one hour, that zone
is bypassed for one hour, starting from the time of the third trigger.
During that hour, if the system detects a trigger on that zone again, the