Filter
Top Products
12
© 2005 directed electronics, all rights reserved
auxiliary channel bypass
All alarm sensor inputs will be bypassed while a pulsed or timed auxil-
iary output is active.
panic mode
If you are threatened near your vehicle, you can attract attention by
triggering the system with your remote! Just press for two sec-
onds to enter Panic Mode. The siren will sound and the indicator lights
will flash for the programmed duration (5-minutes maximum). To stop
Panic Mode at any time press on the remote again.
valet mode
You can prevent your security system from automatically arming by
using Valet Mode. This is very useful when washing the motorcycle for
example. In Valet Mode, the security system will not arm, even with the
remote, but any accessory functions will continue to work normally.
To enter Valet Mode:
1. Turn the ignition On.
2. Enter the PIN code as described in the Disarming
Without a Remote section.
3. When you enter the last digit continue to hold the
button for at least three seconds then
release. The LED status indicator will light up and