Filter
Top Products
20
© 2005 directed electronics, all rights reserved
power saver mode
z
When in Valet mode, the LED will turn off 1-hour after enter-
ing Valet mode.
z
After 24 hours in the armed state, the LED will decrease the
flash rate to
1
/2 the normal rate; after 48 hours it will decrease
to
1
/4 the normal rate.
z
After 96 hours of no activity (arm, disarm, or alarm trigger) the
alarm enters sleep mode. The alarms receiver, and LED turn off
to save as much battery power as possible. The system is
drawing next to no current in this mode.
To exit sleep mode turn the ignition on and the siren will
chirp 10 times (5-seconds) before the siren sounds.
Disarm the system with the remote or by entering the
PIN code with the Valet switch.
If any other input is activated when in sleep mode, the
system will wake up and trigger the alarm immediately.
system sensors and adjustments
Your system was installed with an integral Tilt sensor. Optional sensors
such as the 504D Double-Guard Shock sensor or 508D Dual-Zone
Proximity sensor may also have been installed.
For adjustments to all sensors/options, please return your motorcycle to
the installing Directed
®
dealer.