Filter
Top Products
24
© 2004 Directed Electronics, Inc.
dealer. The majority of transponder-based immobilizer systems
can be bypassed using the 555U/556U immobilizer bypass
module available at your local retail dealer.
This BLUE wire (H1/1) of the primary harness supplies a
200mA output as soon as the control module begins the remote
start process. This wire can be used to activate an immobilizer
bypass unit.
To determine what bypass module your vehicle requires, check
your web vehicle information sheet.
step 9
The system comes with one transmitter. The receiver can store
up to 2 different transmitter codes in memory. Use the following
to learn the transmitter or to add a transmitter to the system.
The following is the basic sequence of steps to remember whenever
programming this unit:
1.
KKeeyy..
Turn the ignition to the ON position.
note: The system can only learn, after
being connected and with the FIRST
IGNITION ON. If not learned with
the first ignition on the battery will
have to be disconnected and then
reconnected and the procedure
repeated.
note: If power is lost to the control module (battery dis-
connected), the transmitters must be relearned.
➜