Filter
Top Products
14
© 2004 Directed Electronics, Inc.
If the vehicle requires more than one ignition as per the Web site
information follow the same test procedure and solder the thick
PINK/WHITE (F) relay wire to it and be sure to wrap the
connection with electrical tape. If your vehicle requires more
than two ignitions, contact BOA Technical Support.
step 3
Accessory and Starter wires
The starter and accessory wires will be located in the same harness
as the ignition and constant power.
To find the accessory wire leave the LED tester black lead
connected to the metal ground, take the red lead and probe the
wire suspected to be the accessory. With the key off, your LED
tester should not illuminate. Turn the key to the on position and
the LED tester should be illuminated. Now turn the key to the
crank position. If you have the correct accessory wire the voltage
will disappear while the starter is cranking and return once the key
returns to the on position. If the wire tests correctly, strip the insu-
lation off a small portion and solder the thick ORANGE (C) relay
wire to it and wrap it with electrical tape. If your vehicle requires
more than one accessory contact BOA Technical Support.
➜