Filter
Top Products
13
© 2004 Directed Electronics, Inc.
Once the constant power wire (or wires) has been identified, solder
the two thick RED wires from the control module to it and cover
the connection with electrical tape to ensure a safe connection.
With the black lead still in the kick panel, locate the ignition
wire harness in the same location. It will test differently than
constant (+)12 volts. Locate the suspected wire using the
www.boasecurity.com web site and then use the LED tester to
probe the suspected wire. With the key in the off position the
LED tester will not illuminate. Turn the key to the on position
and the LED tester will illuminate. Now while watching the
LED tester, turn the key to the crank position and the LED
tester should not extinguish. If the LED tester extinguishes this
is not an ignition wire but an accessory wire. If the wire tests
correctly, solder the PINK (C) relay wire to it and cover the
connection with electrical tape.
warning! Before making any connection
to constant battery power make sure that
the two green 30 amp fuses are removed
from the fuse holders on the two thick red
wires. Failure to do so may cause fire or
shorting of sensitive electrical components.