Filter
Top Products
Page 5
TESTING LIGHTS BEFORE USE
1. Check that the WHITE (ground) wire of the wiring harness
is connected to the Kar Kaddy frame and the WHITE
(ground) wire is connected to the frame of the towing
vehicle.
2. With headlights in "ON" position, the tail lights, the light
cluster bar, the license plate light, and the clearance lights
should be lighted.
3. Start engine and have someone depress brake pedal.
Brake lights of tow dolly and towing vehicle should come
"on" and "off" simultaneously with each application.
4. Turn left turn signal on. Left turn light of Kar Kaddy and
towing vehicle should flash simultaneously. Should the
turn signal lights of the trailer function opposite to those of
the towing vehicle, it is probable that the YELLOW (Driver
side) and GREEN (Passenger side) wires have been
reversed. Check the plug connection under the tongue of
the Kar Kaddy to make sure wire colors are not crossed at
that point. If plug connection is incorrect, correct problem
by reversing yellow and green wire connection on the
towing vehicle.
Step 1. Secure ball coupler to 2" (5,000 lb. capacity) towing
vehicle ball only. Make sure that the hitch and the hitch ball
are in good condition and not rusted, loose or stripped.
Recommended ball height is 18" to the top of the ball.
Make sure hitch is locked down and secured with safety clip.
Criss-cross safety chains under tongue and secure to towing
vehicle frame.
LOADING INSTRUCTIONS
Refer to load limits on inside of front cover.
Step 3. Loosen wing nut on back of license plate holder, turn
the clip on the front to a horizontal position and put license in the
"down" position. Turn the clip back so it rests against the back
of the light bar to hold the license down and tighten wing nut.
(License must be "UP" with the tow dolly empty).
Step 2. Remove black locking pin BEFORE loading vehicle
onto the Kar Kaddy. The removal of the locking pin allows
"Auto Steer" to operate. When towing the dolly empty, this pin
must be in place.
IMPORTANT: Tire tread width or body width of towed
vehicle must not exceed:
KK260 - 70" max. (outside to outside),
42" min. (inside to inside),
72" max. (body width).
KK360 - 76" max. (outside to outside),
42" min. (inside to inside),
78" max. (body width).
Step 4. Before loading (and unloading) towed vehicle make
sure platform and towed vehicle are in straight alignment. Tow
dolly must be completely and properly hooked up to the towing
vehicle. Towing vehicle must be larger and at least 1000
lbs. heavier than the tow dolly and towed vehicle com-
bined.